Myalarm V-LCD1 Manual de instrucciones descargar pdf (Pagina 239)

PC/VDT PROGRAMMING - BATCH ENROLL DATA CHIPS

9-233

System 2 Installation / Programming Manual

System Function While Batch Loading

IMPORTANT NOTE: The system will not process door inputs while batch loading is in

operation. This means that users entering their code at a door will not be granted access while

the system is batch loading. For this reason, it is important that batch loading be performed at

non-peak times so as to minimize user inconvenience.

At this point, the VDT will display the following instructions:

Enter Number

Touch Data Chip or

Enter Chip Number

Use Bckspc to correct

Enter Chip

Keep touching all the Data Chips you wish to program. The actual code will not print on the

VDT... but, if you look closely the VDT will advance to the same prompt until you are finished.

Be sure to “List Users” (Option 12) after you have programmed all you Data Chips into the

System.

If you wish to re-enter Data Chips, and you do not have them “in-hand”, you must have the full

16-digit code. This code will print when you List Users. Since the code contains alphanumeric

characters a PC or VDT is also needed to re-enter these chips.

After you Batch Enrolled these Data Chips the VDT will display:

Use Up to 4 Digits

First User # [_____]

If you wish to batch program additional users, enter the desired first user number followed by

ENTER at the First User # [_ _ _ _] prompt. If you are finished batch

programming users press 0 and ENTER.

Memory Full

At some point, you may enter the maximum number of users supported on your version of

System 2. Should this happen, the VDT will display the instructions:

Press Any Key

0=Quit

No More Room!

You now have a decision to make. Either remove any unused codes, or call Corby about

purchasing the memory expansion option. After you have successfully entered all users, the

unit will return to the Main Menu.

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 335 336

Sin comentarios

Myalarm V-LCD1 Manual de instrucciones Pagina 239