Myalarm V-LCD1 Manual de instrucciones descargar pdf (Pagina 195)

100

101

PC/VDT PROGRAMMING - AUXILIARY OUTPUTS

9-189

System 2 Installation / Programming Manual

Trigger Event

As we mentioned above, an output can be triggered by a System event. Example: If you are

programming Auxiliary Relay #1, and want it to activate when an invalid code is used at one of

the readers, select 11 - Inv Code. You can now wire this Relay to a light, bell, whistle, etc. and

each time there is an invalid code Auxiliary Relay #1 will activate.

If you do not wish these outputs to activate from any System event, press 0.

At this point, you may select which event, if any, will trigger this output.

The VDT will display the instructions:

1=System Reset

2 = AC Off

3 = AC On

4 = Memory Clear

5 = Relay Override

6 = Door Ajar

7 = Door Closed

8 = Forced Entry

9 = Valid User

10= Inv

11 = Inv Code

12 = PIN Error

13 = Sched Error

14 = Request To Exit

15 = Unknown Event

16 = AP Error

17 = Door Perm

18 = Daylight Savings

19 = Powerup

20 = Zone On

21 = Zone Off

Enter (0 for None) [_0]

At the Event (0 for None) [_ 0] prompt, enter your selection followed by ENTER.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 335 336

Comentarios a estos manuales

Sin comentarios

Myalarm V-LCD1 Manual de instrucciones Pagina 195

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Myalarm V-LCD1