Myalarm V-LCD1 Manual de instrucciones descargar pdf (Pagina 123)

LCD PROGRAMMING - BATCH ENROLL KEYPAD CODES

8-117

System 2 Installation / Programming Manual

Use 4 Digits

Enter Seed # [ _ _ _ _ ]

Assign These Output(s) þþþþ

Outputs [ - - - - ]

Seed Number

What is a Seed Number? Here’s an example: You select a seed number of 1000, Batch Enroll

200 users, and use the System for months or years. One day, someone accidentally erases

memory. Now everyone’s codes are erased. No problem! When Batch Enrolling Users again,

simply select Seed Number 1000 again, and the System will assign the identical codes it did

previously, saving you time of issuing new numbers, and users the aggravation of memorizing a

new code number. Of course, you need to be sure to write down the seed number and store it in

a safe place for future use.

The Seed Number must be four digits. Again, you may not use Leading Zero’s.

The LCD will scroll the instructions:

Additional Outputs

When a valid code is entered, the door relay for that Port will be activated. In addition to this

activation, you might want other outputs to be activated to sound an alarm, trip a dialer, or send

some other signal. There are four such outputs from which to choose. The Port programming

section of this manual details the physical properties of the outputs. Any, all, or none of these

outputs may be triggered by a valid code entry if the Second Door is activated. Refer to Option

#13 to purchase this option.

The LCD will scroll the instructions:

Scrolling Options: to User ID

1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

0=None

At the Outputs [ - - - - ] prompt, enter the desired output(s), if any, then press #.

Example: If you select 1 (Auxiliary Relay 1) and 3 (Voltage Output 1) after someone in this

group enters a valid code or uses a valid Card the door will be activated and the Auxiliary Relay

#1 and Voltage Output #1 will activate.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 335 336

Sin comentarios

Myalarm V-LCD1 Manual de instrucciones Pagina 123