Myalarm V-LCD1 Manual de instrucciones descargar pdf (Pagina 131)

LCD PROGRAMMING - BATCH ENROLL CARDS

8-125

System 2 Installation / Programming Manual

Use 4 Digits

Enter Seed # [ _ _ _ _ ]

Assign These Output(s) þþþþ

Outputs [ - - - - ]

Seed Number

If you do not intend to use Keypads on your system, exit this option and return to Option #5 -

Port Configuration and set all your ports to Card Only.

What is a Seed Number? Here’s an example: You select a seed number of 1000, Batch Enroll

200 users, and use the System for months or years. One day, someone accidentally erases

memory. Now everyone’s codes are erased. No problem! When Batch Enrolling Users again,

simply select Seed Number 1000 again, and the System will assign the identical codes it did

previously, saving you time of issuing new numbers, and users the aggravation of memorizing a

new code number. Of course, be sure to write down the seed number and store it in a safe place

for future use.

The Seed Number must be four digits. Again, you may not use Leading Zero’s.

Note: This prompt will only appear if any of your ports are selected as Card or Keypad

or Card and Keypad. Remember, the system default is for Keypad Only. If you have the

network option active and any of the up to sixteen ports have not been changed to Card Only (if

this is what you desire), you will have to enter a seed number here.

The LCD may scroll the instructions:

Enter your four digit seed number and press #.

Additional Outputs

When a valid card is entered, the door relay for that Port may be activated. In addition to this

activation, you might want other outputs to be activated to sound an alarm, trip a dialer, or send

some other signal. There are four such outputs from which to choose. The Program Aux

Outputs section of this manual details the physical properties of the outputs. Any, all, or none of

these outputs may be activated by a user, if the Second Door is activated.

Refer to Option #13 to purchase this option.

The LCD will scroll the instructions:

Scrolling Options: to User ID

1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

0=None

At the Outputs [ - - - - ] prompt, enter the desired output(s), if any, then press #.

Example: If you select Outputs 1 and 3, each time this group enters their code the door will

open and Aux Relay 1 and Voltage Output 1 will activate... provided you have installed a two-

door System 2 (2016).

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 335 336

Sin comentarios

Myalarm V-LCD1 Manual de instrucciones Pagina 131