Myalarm V-LCD1 Manual de instrucciones descargar pdf (Pagina 213)

PC/VDT PROGRAMMING - ADD/CHANGE DATA CHIPS

9-207

System 2 Installation / Programming Manual

If you select Port #3 and you do not have this System set-up for networking, the VDT will

display:

Error!

Entry Out of Range!

Press Any Key

To enable more than two doors, the Networking Option needs to be installed. Proceed to

Option #13 for installation instructions.

When you are finished entering door numbers press 0.

User Chips

If either Port is programmed for Data Chip, you will be prompted to enter a Data Chip Number.

If using Data Chips, you can either touch the Data Chip to the test point at the upper right hand

corner on the System 2 circuit board or use the optional “Data Chip wand reader”.

At this point, the VDT will display the following instructions:

Enter Number

Touch DataChip or

Enter Chip Number

Use Bckspc to correct

0 to Quit

Enter Chip

Be sure to “List Users” (Option 11 - Reports) after you have programmed all you Data Chips

into the System. If you wish to re-enter Data Chips, and you do not have them “in-hand”, you

must have the full 16-digit code. This code will print when you List Users. Since the code

contains alphanumeric characters a PC or VDT is also needed to re-enter these chips. If you

were successful in entering your Chip, proceed to Entering Additional Outputs.

Duplicate Code!

If you happen to attempt to enter a Chip which is already used, you will see the prompt:

Press Any Key

Duplicate!

If this happens, simply select another chip or delete the existing chip.

For more information, see Option 10 - Deleting Users.

1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 335 336

Sin comentarios

Myalarm V-LCD1 Manual de instrucciones Pagina 213