Page 99
APPENDIX D – FIRMWARE UPDATES
Description
The OmniPro II Version 3.2 firmware adds the following new features:
• Support for Clipsal C-Bus Lighting Control
The OmniPro II Version 3.1 firmware adds the following new features:
• Added LEVITON Trigger messages for simple integration with remote serial devices
• Support for Lutron HomeWorks Whole Home Lighting Control System
• Added Z-Wave Status Request Command
• Added automatic polling for Z-Wave Thermostats
The OmniPro II Version 3.0 firmware adds the following new features:
• User Settings
• Enhanced Programming
• Real-Time operation status of thermostats
• Support for Omnistat2 Thermostats
• OmniTouch support for real-time cool/heat/humidify/dehumidify status
• Automatic cycling of switched power when the system is disarmed
• OmniTouch menu operation support for the NuVo Grand Concerto and Essentia G audio systems
• OmniTouch support for Russound E-Series (Sphere) audio systems
• Third-Party Protocol Enhancements
• Support for LEVITON Access Control
Note: Loading new screens into each OmniTouch touchscreen may be necessary to support new features in Version 3.0
Firmware. Ensure that each OmniTouch is running “Screens Version “9”. To check, press the “Setup” icon from the Home page.
Next press the “Screen Setup” icon, followed by the “Next” button. The “Screens Version” should be displayed on the bottom
left of the display. If the “Screens Version” is lower than “9” or if the text “Screens Version” is not displayed, the screens must
be updated.
About Clipsal C-Bus
Clipsal C-Bus uses a network of low voltage wires for communications between C-Bus lighting devices and also provides a small
amount of power to operate each C-Bus lighting devices in your home. Each switch or dimmer controls one lighting load in a
Clipsal C-Bus system. They are used in place of standard light switches and allow local control as well as remote control from
any of the Clipsal C-Bus keypads, an OmniPro II interface, or via programming in the OmniPro II controller.
Clipsal C-Bus Format
OmniPro II groups devices by “House Code”, which consists of 16 consecutive unit numbers, starting at Unit 1. Each “House
Code” can be configured to a different lighting protocol format such as: Standard X-10, Extended X-10, Lightolier Compose,
UPB (open UPB format where you can use the programming capability in the OmniPro II controller to communicate with the
UPB network), Lutron RadioRA, LEVITON Lighting Control (HLC), CentraLite, Vizia RF Z-Wave, Lutron HomeWorks, or
Clipsal C-Bus.
Each LEVITON lighting unit can be associated with a corresponding C-Bus lighting group. OmniPro II supports 254 C-Bus
lighting groups. LEVITON unit 1 corresponds to C-Bus lighting group address 1; LEVITON unit 2 corresponds to C-Bus
lighting group address 2; and so on.
(8 paginas)
(362 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales