Myalarm V-LED1 Manual de usuario Pagina 4

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 3
hardware integration on the
MC13192-SARD, the design of this
sensor was software only, but this pro-
vided an easy starting point to start
software development and quickly
implement a sensor for the validation
of the base unit’s reception abilities.
The garage door module uses the
Freescale MMA1260D 1.5-g z-axis
accelerometer included on the
www.circuitcellar.com
CIRCUIT CELLAR
®
Issue 194 September 2006
33
nected to the microcon-
troller through 5- to 3-V
logic level translation.
DTMF detection is per-
formed by a BG Micro
SSI204 DTMF detection
IC. Given more develop-
ment time, I would have
been able to implement a
DTMF detection routine
in software, but I
would’ve needed hardware
to amplify the incoming
phone line audio to a
range suitable for the
ADC on the GT60 proces-
sor. The SSI204 chip
interfaces directly to the
DAA audio output with nothing more
than a 0.1-µF capacitor.
GARAGE DOOR SENSOR
I started the remote sensor design
with the garage door module because
all of the required hardware was
already part of the MC13192-SARD
PCB, with one minor exception I will
discuss later. With the high level of
MC13192-SARD PCB to detect the
position of the garage door. The
MC13192-SARD periodically wakes
up, checks the accelerometer, and
sends an error code when –1 g (due to
the force of gravity) is seen. The PCB
must be mounted on the garage door
with the solder side toward the door
so that it is horizontal and upside
down on the raised garage door.
Figure 2
The MPX2010GS sensor measures the water level by the air pressure in the tube. The op-amp circuitry changes the differential
sensor signal to a ground-referenced signal and amplifies the signal to a range appropriate for the MC13192 SARD board’s analog input.
2609016 Smith.qxp 8/4/2006 2:19 PM Page 33
Vista de pagina 3
1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios